Starting A Program - Miele PG 8527 Operating Instructions Manual

Operation
Opening and closing the door
^ Press the a button.
The door raises or lowers.
To open the door on the clean side
(PG 8528), the following must also
apply:
– Programs with a process statement
must have been completed without
fault in accordance with the program
parameters,
or
– the interlock function has been
activated, i. e., door mechanism is
set to one of the following
parameters:
- interlock,
- door clean + interlock,
- door unclean + interlock.
(see Programming Manual under
"Machine functions / Door
mechanism").
,
If the pre-heater has been
programmed for heating, always
beware of hot water or steam exiting
the open door! Looking from the
unclean side, the inlet pipe is
located beneath the right basket
guide rail.
46

Starting a program

You can find detailed and important
information regarding the Miele
default programs in the program
overview chart in the accompanying
Programming Manual.
,
Any program or dosing changes
in connection with the preparation of
medical devices must be
documented.
In such cases, the
washer-disinfector results (cleaning,
disinfection) will need to be
re-validated.
If a barcode scanner is connected to
the washer-disinfector and the user
or load scan is activated, the
selected program cannot be started
until scanning is completed.
All work steps in connection with the
barcode scanner are described in
the "Barcode scanner" section.