Operation; Main Switch - On/Off; Switching On - Miele PG 8527 Operating Instructions Manual

Main Switch - On/Off

The main switch disconnects the user
side of the washer-disinfector from the
power supply.
^ Turn the main switch to I ON.
Once the start procedure is completed,
the washer-disinfector is ready to
operate.
The following message may appear: "
"New power frequency 60Hz Flow
rates automatically adjusted" or "New
power frequency 50Hz Flow rates
automatically adjusted".
During the start procedure, the
Profitronic detected a different power
frequency and adjusted the flow rate
of the dispensing pump accordingly.
Before operation, you will need to
check whether the change in power
frequency was caused by a fault in
the power supply.
If so, incorrect amounts of
processing chemicals would be
dispensed during the program.
The fault message can only be
confirmed in operating level D and in
the service mode.

Switching On

^ Hold down the s button for at least
1.5 sec.
The actuating time for the s button
can be set up to a maximum of 10
sec. (see for the section on "System
functions /Actuating time ON/OFF
Button" in the ).
Depending on the set operating level,
the following will appear in the display:
Operating Displayed
levels
A and B A list of approved
programs.
C Instructions for Automatic
Mobile Unit Recognition.
D Select from:
– Program Overview
– Programming
– Settings J.
If the washer-disinfector is not in use,
the display automatically switches off
after approx. 10 min.
To turn the display back on, touch
any button.

Operation

45