Eco Network Power - Hitachi CP-WU13K User Manual

OSD Menu description
CONTROL
IR Address
Use this function to configure the projector's IR code receive commands from the remote control.
The default value is 1.If you have other equipment in your home that could pick up the command from
the projector's remote control, it is recommended that you set the remote control code to 2.
When you are running two projectors via serial connection, you can set the code on one projector as "1"
and "2" for the other projector. By doing so, you will be able to control two projectors with the same
remote control.
When you want to switch your remote control from code 1 projector to code 2 projector, press and
hold the ENTER and ADDRESS buttons on the remote control simultaneously (for approximately 5
seconds); the backlight module on the remote control will blink to confirm the switch.

Eco Network Power

The projector can be connected to a network via its RS-232 port and 10/100 BASE-T port for remote
operation with two separate boards to control the signal sources from RS-232 and 10/100BASE-T
ports. But this function "Eco Network Power" is only available for 10/100BASE-T, will not active
when the input source is RS-232.
If you do not require remote operation of the projector over a network, it is recommended that you
set this function to On to activate the ECO Network Power. This will turn off the power that is used
to control the 10/100 BASE-T board. However, you will not be able to operate the projector remotely
over a network as long as the function remains activated.
By setting it to Off, the function will be disabled. You won't be able to conserve power but you can
control the projector remotely over a network.
50