Installation Of The Projector; Orient The Projector Towards The Screen - Hitachi CP-WU13K User Manual

Installation the projector.

1. Orient the projector towards the screen

Screen
10/100 BASE-T
2. Connect the power cord to the projector

Please select the
Desk Top or Notebook
correct input voltage
IN OUT
before removing the
SDI / HDSDI / 3G
warning label.
Please note that select the correct input (115V or 230V) voltage according to the area where you operate the projector
before you turn on the power switch.
3. Connect the projector to your PC and flip the switch to "I" to turn on the
power.
10/100 BASE-T

Desk Top or Notebook
IN OUT
SDI / HDSDI / 3G
4. Remove the lens PU foam on the projector before starting it up.
12V TRIGGER
RS-232
I
HDMI  HDMI 
VOLTAGE SELECT
連接至牆壁插座
12V TRIGGER
RS-232 WIRED REMOTE
I 350mA II
VGA G/Y
HDMI  HDMI 
連接至牆壁插座
Press the
the
AC MAINS
start up the projector.
100-240 Volts
50/60Hz

Installation of the Projector

WIRED REMOTE
350mA
II
AC SWITCH
VGA G/Y
COMPONENT 1
SYNC IN
Y Pb Pr
B/Pb R/Pr H V STEREO DVI
COMPONENT 2
AC MAINS
100-240 Volts
50/60Hz
AC SWITCH
button on the projector or
l button on the remote control to
COMPONENT 1
Y Pb
B/Pb R/Pr H
COMPONENT 2
SYNC OUT
AC SWITCH
SYNC IN SYN
Pr
V STEREO DVI
15