Table of Contents
Advertisement
OSD Menu description
ALIGNMENT
Rear Projection
The default setting is Off.
When you have set up the projector for rear projection, please set it to ON. For more information on
different modes of projection,
Ceiling Mode
The default setting is Off.
When you have set up the projector for ceiling mode (hung from the ceiling in reverse), please set
it to ON. For more information on different modes of projection,
installation ".
Lens Control
Zoom
•
This function is identical to the one covered in previous sections.
Adjusting focus and zoom. ".
Focus
•
This function is identical to the one covered in previous sections.
Adjusting focus and zoom. ".
Shift
•
This function is identical to the one covered in previous sections.
Adjusting the projector's angle ".
Dynamic Contrast
Use this function to configure the projector to automatically adjust image contrast from the source
upon start up or shut down. When activated, the projector will dynamically adjust the image contrast
from the beginning of the projection until the content has ended.
44
refer to " Page 18 : Modes of installation ".
refer to " Page 18 : Modes of
Refer to " Page 16 : 6.
Refer to " Page 16 : 6.
Refer to " Page 16 : 5.
Advertisement
Table of Contents
