Control; Ir Address; Eco Network Power - Hitachi CP-WU13K User Manual

OSD Menu description

CONTROL

IR Address

8VH WKLV IXQFWLRQ WR FRQ¿JXUH WKH SURMHFWRU¶V ,5 FRGH UHFHLYH FRPPDQGV IURP WKH UHPRWH FRQWURO
The default value is 1.If you have other equipment in your home that could pick up the command from
WKH SURMHFWRU¶V UHPRWH FRQWURO LW LV UHFRPPHQGHG WKDW \RX VHW WKH UHPRWH FRQWURO FRGH WR 
When you are running two projectors via serial connection, you can set the code on one projector as "1"
and "2" for the other projector. By doing so, you will be able to control two projectors with the same
remote control.
When you want to switch your remote control from code 1 projector to code 2 projector, press and
hold the ENTER and ADDRESS buttons on the remote control simultaneously (for approximately 5
VHFRQGV WKH EDFNOLJKW PRGXOH RQ WKH UHPRWH FRQWURO ZLOO EOLQN WR FRQ¿UP WKH VZLWFK

Eco Network Power

The projector can be connected to a network via its RS-232 port and 10/100 BASE-T port for remote
operation with two separate boards to control the signal sources from RS-232 and 10/100BASE-T
ports. But this function "Eco Network Power" is only available for 10/100BASE-T, will not active
when the input source is RS-232.
If you do not require remote operation of the projector over a network, it is recommended that you
set this function to On to activate the ECO Network Power. This will turn off the power that is used
to control the 10/100 BASE-T board. However, you will not be able to operate the projector remotely
over a network as long as the function remains activated.
%\ VHWWLQJ LW WR 2II WKH IXQFWLRQ ZLOO EH GLVDEOHG <RX ZRQ¶W EH DEOH WR FRQVHUYH SRZHU EXW \RX FDQ
control the projector remotely over a network.
50