Description Pertaining To Fcc Rules Part 15 - Hitachi CP-WU13K User Manual

Hide thumbs Also See for CP-WU13K:
Table of Contents

Advertisement

Warning, Notices and Safety Instructions
Warning, Notices and Safety Instructions
Notice
Please write down your projector model number and serial number and keep the information for
maintenance purposes in the future. Should the equipment be lost or stolen, the information could also
be used for the police report.
Model number:
Serial number:
Please check the accessories that come with the projector with the following list. Should you find any
missing accessory, contact your dealer immediately.
1. AC Power Cord US 110V*1
2. AC Power Cord US 200V*1
3. AC Power Cord EU*1
4. Remote control *1
5. AA battery *2
6. CD-ROM *1
7. Printed Manual *1
8. EAC Document *1
9. EU Recycle Sheet *1
10. WEEE Manual *1
11. RS232 cable(cross) *1

Description pertaining to FCC Rules Part 15

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This device has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy. If not installed and used in
accordance with the instructions, may cause harmful interference to radio or television reception.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment in to an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
4

Advertisement

Table of Contents
loading

Table of Contents