Servicing The Engine Oil And Filter; Adjusting The Throttle - Toro 30856 Operator's Manual

5. Install the cover orienting the rubber outlet valve in
a downward position—between approximately 5:00
to 7:00 when viewed from the end.
6. Reset the indicator (Figure 31) if it shows red.
Servicing the Engine Oil and
Filter
Service Interval: After the first 50 hours
Every 150 hours
Change the oil and filter initially after the first 50 hours
of operation; thereafter change the oil and filter every
150 hours.
1. Remove the rear drain plug (Figure 35) and let the
oil flow into a drain pan. When the oil stops, install
the drain plug.
1. Engine oil drain plug
2. Remove the oil filter (Figure 36). Apply a light coat
of clean oil to the new filter seal before screwing it
on. Do not overtighten.
1. Engine oil filter
3. Add oil to the crankcase; refer to Checking the
Engine Oil in , page .
Figure 35
Figure 36

Adjusting the Throttle

Adjust the throttle cable (Figure 37) so that the governor
lever on the engine contacts the low and high speed set
bolts before the throttle lever contacts the slot in the
seat base.
1. Throttle cable
35
Figure 37