Toro 30856 Setup Instructions

Groundsmaster 4500-D
Groundsmaster Traction Unit
Model No. 30856—Serial No. 230000701 and Up
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts
Note: Use this chart as a checklist to ensure that all parts necessary for assembly have been received. Without these parts,
total setup cannot be completed. Some parts may have already been assembled at the factory.
Description
Throttle stop
Set screw
Lift latch
Latch bracket –R.H.
Latch bracket –L.H.
Flange lock nut 1/4–20
Lock bracket
Screw 1/4–20 x 1/2"
Washer .281 x .625
Lock nut 1/4–20
EEC decals
EEC certificate
Install Throttle Stop
1. Loosen set screw on throttle stop.
2. Slide throttle stop onto high idle stop screw (Fig. 1).
Slot in throttle stop to be positioned over rib on engine.
3. Start engine and allow to run for 5 to 10 minutes. The
temperature gauge needle should be in the yellow
before proceeding to next step.
4. If cutting units are equipped with standard angled sail
blades, adjust high idle to 2575 rpm with the cutting
units disengaged. If equipped with high lift parallel sail
blades, adjust high idle to 2550 rpm with the cutting
units disengaged.
5. Tighten setscrew. Apply adhesive into setscrew to
prevent tampering.
2003 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
CE Compliance Set Up Instructions
Qty. Use
1
Install for CE compliance
1
1
1
Install on control console for CE compliance
1
2
1
1
Install on hood latch for CE compliance
1
1
2 Apply to machine for CE compliance.
2
1. Throttle stop
1
Form No. 3350–720
2
1
Figure 1
2. Set screw
All Rights Reserved
Printed in the USA