Adjusting The Anti-Scalp Rollers - Toro 74904 Operator's Manual

Adjusting the Height-of-Cut Pin
The height-of-cut is adjusted from 25 to 140 mm (1 to
5-1/2 inches) in 6 mm (1/4 inch) increments by relocating
the clevis pin into different hole locations.
1. Move the transport lock to the
2. Push on the deck-lift pedal with your foot, and raise the
mower deck to the transport position (also the 140 mm
(5-1/2 inches) cutting height position) as shown in
Figure 26.
3. To adjust, rotate the pin 90 degrees and remove the pin
from the height-of-cut bracket
4. Select a hole in the height-of-cut bracket corresponding
to the height-of-cut desired, and insert the pin
26).
5. Push on the deck lift, pull back on the transport lock,
and slowly lower the mower deck.
Figure 26
1. Deck-lift pedal
2. Cut-of-height pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, adjust the height
of the anti-scalp rollers.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the N
and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
position.
LOCK
(Figure 26).
(Figure
3. Transport lock
-L position,
EUTRAL OCK
3. Adjust the anti-scalp rollers as shown in
Figure 28, and Figure
1. Anti-scalp roller
2. Spacer
3. Bushing
1. Anti-scalp roller
2. Bushing
26
Figure
29.
Figure 27
4. Flange nut
5. Bolt
Figure 28
3. Flange nut
4. Bolt
27,