Figure 60
1. Positive battery post
2. Negative battery post
Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check the
component/circuit for a malfunction or short.
1. The fuses are located on right console next to the seat
(Figure
61).
2. To replace the fuses, pull out the fuse to remove it.
3. Install a new fuse
(Figure
Figure 61
1. Optional accesory—15 A
2. Charge—25 A
3. PTO—10 A
3. Red (+) charger lead
4. Black (-) charger lead
61).
g020464
4. Main—25 A
5. Console
Drive System
Maintenance
Checking the Seat Belt
Service Interval: Before each use or daily
Visually inspect seat belt for wear, cuts, and proper operation
of retractor and buckle. Replace the seat belt before operating
the machine if the belt is damaged.
Checking the
Rollover-Protection System
(ROPS) Knobs
Service Interval: Before each use or daily
WARNING
To avoid injury or death from rollover, keep the roll
bar in the fully raised locked position and use the
seat belt.
Ensure the seat is secured to the machine.
Check that both the mounting hardware and the knobs are
in good working condition. Make sure that the knobs are
fully engaged with the ROPS in the raised position. You may
need to push the upper hoop of the roll bar forward or pull it
rearward to fully engage both knobs
45
(Figure
62).