Adjusting The Motion-Control Damper; Adjusting The Motion Control Neutral-Lock Pivot - Toro 74904 Operator's Manual

14. Check that the machine does not creep in neutral with
the park brakes disengaged.
Adjusting the Motion-Control
Damper
You can adjust the top damper mounting bolt to obtain a
more desired motion-control lever resistance. See
for mounting options.
Right Control Shown
1. Torque the locknut to 23 N-m (17 ft-lb). The bolt must
protrude past the end of the locknut after torquing.
2. Most resistance (firmest feel)
3. Damper
4. Medium resistance (medium feel)
5. Least resistance (softest feel)
Figure 83
Figure 83
Adjusting the Motion Control
Neutral-Lock Pivot
You can adjust the flanged nut to obtain a more desired
motion-control lever resistance when moving it to the
N -L position. See
EUTRAL OCK
options.
1. Loosen the jam nut.
2. Tighten or loosen the flanged nut to the desired feel.
Note: For more resistance, tighten the flanged nut.
Note: For less resistance, loosen the flanged nut
3. Tighten the jam nut.
1. Flanged nut
55
Figure 84 for adjustment
Figure 84
2. Jam nut