Setting The Powered Zone 2; Using Zone 2 - Onkyo HT-RC270 Instruction Manual

Setting the Powered Zone 2

If you've connected your Zone 2 speakers to the AV
receiver, as explained in "Connecting Your Zone 2 Speak-
ers Directly to the AV receiver"
"Powered Zone2" setting to "Act" (Activated).
1
Press RECEIVER followed by SETUP.
The main menu appears onscreen.
Tip
• If the main menu doesn't appear, make sure the appropri-
ate external input is selected on your TV.
2
Use q/w to select "Speaker Setup", and then press
ENTER.
The "Speaker Setup" menu appears.
2. Speaker Setup
1. Speaker Settings
2. Speaker Configuration
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
3
Use q/w to select "Speaker Settings", and then
press ENTER.
The "Speaker Settings" menu appears.
2–1. Speaker Settings
Speaker Impedance
Speakers Type(Front)
Powered Zone2
4
Use q/w to select "Powered Zone2", and use e/r
to select:
Not Act:
Use FRONT WIDE/ZONE 2 L/R terminals to
connect front wide speakers (Powered Zone 2
disabled).
Act:
Use FRONT WIDE/ZONE 2 L/R terminals to
connect Zone 2 speakers (Powered Zone 2
enabled).
5
Press SETUP.
The setup menu closes.
Note
• Powered Zone 2 cannot be used if "Speakers Type(Front)" is
set to "Bi-Amp" (➔ 44).
• This procedure can also be performed on the AV receiver by
using SETUP, arrow buttons, and ENTER.
(➔ 68), you must set the
6ohms
Normal
Not Act

Using Zone 2

This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust the
volume for Zone 2.
Controlling Zone 2 from the AV receiver
ZONE 2 indicator
OFF
Input selector buttons
ZONE 2
1
To turn on Zone 2 and select an input source, press
ZONE 2 followed by an input selector button
within 8 seconds.
Zone 2 turns on, the ZONE 2 indicator lights.
To select AM or FM, press TUNER input selector
and ZONE 2 repeatedly.
To select the same source as that of the main room,
press ZONE 2 twice. "Zone 2 Selector: Source"
appears on the display.
2
To turn off Zone 2, press ZONE 2.
ZONE 2 indicator flashes.
Press OFF.
The zone is turned off, and the ZONE 2 indicator
goes off.
En
69