Resetting Remote Mode Buttons; Resetting The Remote Controller; Controlling Other Components - Onkyo HT-RC270 Instruction Manual

If you want to control an Onkyo component by pointing
the remote controller directly at it, use the following
remote control codes:
32900:
Onkyo Blu-ray Disc player
32901:
Onkyo HD-DVD player
70868:
Onkyo MD recorder without u
71323:
Onkyo CD recorder without u
82990:
Onkyo Dock without u
Note
• If you connect a cassette tape deck to the TV/CD IN jack, or
connect an RI Dock to the to the TV/CD IN or VCR/DVR IN or
GAME IN jacks, for u to work properly, you must set the Input
Display accordingly

Resetting REMOTE MODE Buttons

You can reset a REMOTE MODE to its default remote
control code.
1
While holding down REMOTE MODE that you
want to reset, press and hold down HOME until
REMOTE MODE lights (about 3 seconds).
2
Within 30 seconds, press REMOTE MODE again.
REMOTE MODE flashes twice, indicating that the
button has been reset.
Each of REMOTE MODE is preprogrammed with a
remote control code. When a button is reset, its pre-
programmed code is restored.
Note
• The learning command is also reset.

Resetting the Remote Controller

You can reset the remote controller to its default settings.
1
While holding down RECEIVER, press and hold
down HOME until RECEIVER lights (about 3 sec-
onds).
2
Within 30 seconds, press RECEIVER again.
RECEIVER flashes twice, indicating that the
remote controller has been reset.
En
78
(➔ 27).

Controlling Other Components

By pressing REMOTE MODE that's been programmed
with the remote control code for your component, you can
control your component as below.
For details on entering a remote control code for other
components, see "Entering Remote Control Codes"
(➔ 77).
Controlling a TV
TV is preprogrammed with the remote control code for
controlling a TV that supports the p
some models). The TV must be able to receive remote
control commands via p and be connected to the
AV receiver via HDMI. If controlling your TV via
p doesn't work very well, program your TV's
remote control code into TV and use the TV remote mode
to control your TV.
Controlling a Blu-ray Disc/DVD Player, HD
DVD Player or DVD Recorder
BD/DVD is preprogrammed with the remote control code
for controlling a component that supports the p
(limited to some models). The component must be able to
receive remote control commands via p and be
connected to the AV receiver via HDMI.
*1
The p supported by the
system control function of the HDMI standard.
*1
(limited to
*1
is the CEC
AV receiver