Connecting The Power/Turning On The Dvd Changer Receiver - Onkyo DR-C500 Instruction Manual

Connecting the Power/
Turning on the DVD Changer Receiver
Before connecting
• Make sure that all the connections from pages 15 to 21 are
complete (the connection to the TV is required).
• Turning on the DVD Changer Receiver may cause a momentary
power surge, which might interfere with other electrical
equipment such as computers. If this happens, use a wall outlet
on a different circuit.
1
Connect the power cord to a wall
outlet.
The DVD Changer Receiver enters the
standby mode and the STANDBY indicator
lights up.
2
Press STANDBY/ON on the DVD
Changer Receiver or the remote
controller to turn on the DVD
Changer Receiver.
The light and display on the DVD Changer
Receiver's front panel light. At the same
time, the STANDBY indicator goes off.
• To put the DVD Changer Receiver in
the standby mode, press STANDBY/ON
on the unit or the remote controller.
Be sure to set the volume to minimum
before putting the unit in the standby
mode for the next use to avoid sudden
loud sound reproduction.
• While in the STANDBY mode, the DVD
Changer Receiver can receive signals
from the remote controller.
• Setting the STANDBY/ON button to
standby does not shut off the power
completely.
STANDBY indicator
STANDBY/ON
Display
Front panel
illumination
23 23