Adjusting The Anti-Scalp Rollers - Toro 74933 Operator's Manual

Figure 24
Transport Lock Positions
1. Transport lock
2. Lock position—mower
deck will lock into transport
position
3. Unlock position—does not
lock the mower deck into
transport position
Adjusting the Height-of-Cut Pin
The height-of-cut is adjusted from 25 to 140 mm (1 to
5-1/2 inches) in 6 mm (1/4 inch) increments by relocating
the clevis pin into different hole locations.
1. Move the transport lock to the lock position.
2. Push on the deck lift pedal with your foot and raise the
mower deck to the transport position (also the 140 mm
(5-1/2 inch) cutting height position) (Figure 25).
3. To adjust, rotate the pin 90 degrees and remove the pin
from the height-of-cut bracket (Figure 25).
4. Select a hole in the height-of-cut bracket corresponding
to the height-of-cut desired and, insert the pin (Figure
25).
5. Push on the deck lift, pull back on the transport lock,
and slowly lower the mower deck.
1
1. Deck lift pedal
2. Cut of height pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
1. Disengage the blade control switch (PTO), move the
motion control levers to the neutral locked position
and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
24
3
Figure 25
3. Transport lock
2
G017027