Throttle Control; Ignition Switch; Motion Control Levers - Toro 74933 Operator's Manual

With 60in and 72in turbo force side discharge mower
Hide thumbs Also See for 74933:
Table of Contents

Advertisement

Battery Indicator Light
If the ignition key is turned to the On position for a few
seconds, the battery voltage will be displayed in the area
where the hours are normally displayed.
The battery light turns on when the ignition is turned on and
when the charge is below the correct operating level (Figure
6).
1. Battery light
2. Hour meter

Throttle Control

The throttle control is variable between Fast and Slow.
Blade Control Switch (PTO)
The blade control switch (PTO) is used to engage the electric
clutch and drive the mower blades. Pull the switch up to
engage the blades and release. To disengage the blades, push
the blade control switch (PTO) down or move a motion
control lever into the neutral lock position.

Ignition Switch

This switch is used to start the mower engine and has three
positions: Start, Run, and Off.

Motion Control Levers

The motion control levers are used to drive the machine
forward, reverse, and turn either direction.
Neutral Lock Position
The neutral lock position is used with the safety interlock
system to engage and to determine neutral position.
Fuel Shut-off Valve
Close the fuel shut-off valve on the cylinder tank when
transporting or storing the mower.
1
g013439
Figure 6
3. Safety interlock symbols
Electronic Control Unit Malfunction
Indicator Light
The electronic control unit (ECU) continuously monitors the
operation of the EFI system.
If a problem or fault within the system is detected, the
malfunction indicator light (MIL) is illuminated.
The MIL is the red light located in the right console panel.
Once the MIL illuminates, initial trouble shooting
checks should be made. Refer to the MIL section under
Toubleshooting.
If these checks do not correct the problem, further diagnosis
and servicing by an Authorized Service Dealer is necessary.
2
Attachments/Accessories
A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
3
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

74934Z master professional 5000 series

Table of Contents