Removing The Mower Deck - Toro 74933 Operator's Manual

the sail area only (Figure 94). Repeat this procedure
until the blade is balanced.
1. Blade
Installing the Blades
1. Install the blade onto the spindle shaft (Figure 94).
Important: The curved part of the blade must be
pointing upward toward the inside of the mower to
ensure proper cutting.
2. Install the spring disk and blade bolt. The spring disk
cone must be installed toward the bolt head (Figure 94).
Torque the blade bolt to 115-150 N-m (85-110 ft-lb).
1. Sail Area of Blade
2. Blade
3. Spring Disk

Removing the Mower Deck

Before servicing or removing the mower deck, the spring
loaded deck arms must be locked out.
WARNING
Deck lift arm assemblies have stored energy.
Removing the deck with out releasing the stored
energy can cause serious injury or death.
Do Not attempt to disassemble the deck from the
front frame without locking out the stored energy.
Figure 93
2. Balancer
Figure 94
4. Blade Bolt
5. Cone Towards Bolt Head
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Remove the height adjustment pin and lower the deck
to the ground.
3. Place the height adjustment pin in the 7.6 cm (3 inch)
cutting height location. This locks the deck lift arms in
the lowest position when the deck is removed and the
stored energy in the deck spring is released.
4. Remove the belt covers.
5. Lift up the floor pan and insert a ratchet into the square
hole in the deck idler (Figure 95).
6. Rotate the deck idler clockwise and remove the mower
belt (Figure 95).
1. Clutch pulley
2. Mower belt
3. Spring loaded idler pulley
4. Ratchet
7. Remove and retain the hardware on both sides of the
deck as shown in Figure 96.
59
Figure 95
5. Square hole in the idler
arm for the ratchet
6. Idler grease zerk
7. Belt guide