Product Overview
©
1. Z Stand
2. Height-of-cut lever
3. Motion control lever
4. Seat belt
5. Roll bar
Controls
Become familiar with all the controls before you start the
engine and operate the machine
1. Hour meter
2. Ignition switch
3. Fuel-selector valve
4. Audible alarm
5. Glow plug switch
g020466
Figure 3
6. Fuel cap (both sides)
7. Parking brake lever
8. Mower deck
9. Caster wheel
(Figure 3
and
Figure
Figure 4
6. Glow plug light
7. Engine temperature light
8. Throttle control
9. PTO Switch
Hour Meter
The hour meter records the number of hours the engine has
operated. It operates when the engine is running. Use these
times for scheduling regular maintenance
Safety-Interlock Indicators
There are symbols on the hour meter and they indicate with a
black triangle that the interlock component is in the correct
position
(Figure
Battery-Indicator Light
When the ignition key is initially turned to the Run position
for a few seconds, the battery voltage will be displayed in the
area where the hours are normally displayed.
The battery light turns on when the ignition is turned on and
when the charge is below the correct operating level
5).
1. Safety-interlock symbols
4).
2. Hour meter
Throttle Control
The throttle control is variable between Fast and Slow.
Blade-Control Switch (PTO)
The blade-control switch (PTO) is used to engage the electric
clutch to drive the mower blades with the motion control
levers in the center, unlocked position. Pull the switch up to
engage the blades and release. To disengage the blades, push
the blade-control switch (PTO) down.
Neutral-Lock Position
The neutral-lock position is used with the safety-interlock
system and to determine neutral position.
Ignition Switch
This switch is used to start the mower engine and has three
positions: Start, Run and Off.
13
(Figure
5).
Figure 5
3. Battery light
4).
(Figure