Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check
component/circuit for malfunction or short.
1. Unlatch the engine hood and raise the engine hood to
gain access to fuse holder
2. To replace the fuses, pull out on the fuse to remove it.
3. Install a new fuse
(Figure
4
Figure 51
1. Ignition-30 amp (F1)
2. Radiator fan-50 amp
(large, heavy duty fuse)
(Figure
51).
51).
1
3
2
G012492
3. Clutch-10 amp (F3)
4. Left side fuel tank
Drive System
Maintenance
Adjusting the Tracking
The machine has a knob for adjusting the tracking located
under the seat.
Important: Adjust the handle neutral and hydraulic
pump neutral before adjusting the tracking. Refer to
Adjusting the Control Handle Neutral Position (page
49)
and
Setting the Hydraulic Pump Neutral Position
(page
52).
1. Push both control levers forward the same distance.
2. Check if the machine pulls to one side. If it does, stop
the machine and set the parking brake.
3. Unlatch the seat and tilt the seat forward to access the
tracking knob.
Note: Determine the left and right sides of the
machine from the normal operating position.
4. To make the machine go right, turn the knob towards
the right side of the machine. Refer to
5. To make the machine go left, turn the knob towards
the left side of the machine. Refer to
6. Repeat adjustment until the tracking is correct.
1. Tracking knob
2. Hydraulic tank
3. Hydraulic pumps
40
Figure
Figure
Figure 52
4. Turn this way to track right
5. Turn this way to track left
52.
52.