Using remote controller
ON
Controlling an Onkyo MD recorder
The
the TX-NR900/900E (see page 28).
1. Press the SAT/MD MODE button.
STANDBY
The SAT/MD MODE button lights.
2. Press the desired operation button.
SAT/MD MODE
The buttons shaded in the figure to the left are the operation
buttons that can be used to control an Onkyo MD recorder.
Operation buttons:
VOL
ON: Turns on and off MD player (same as STANDBY button on the
remote controller)
: Track down
MUTING
: Track up
MD
: Play
operation
buttons
: Stop
: Skip backward
: Skip forward
REC G: Record
: Pause
Numeric keys
: Eject
1 to 9, 0, --/---: Numeric keys
ENTER
ENTER: Enters the settings
You may also use the following buttons:
VOL
MUTING: Activates muting function at TX-NR900/900E
Note:
The SAT/MD button is used for operating satellite tuners and Onkyo
MD recorders. Be aware that if you enter the preset code for a
satellite tuner as shown on page 70, then this button cannot be used
to operate Onkyo MD recorders.
If this is the case, to operate an Onkyo MD recorder, you must first
erase the satellite tuner code by following the directions given in
"Erasing all the commands programmed under a MODE button" on
page 75.
connector of the Onkyo MD recorder must be connected to
: Adjusts volume at TX-NR900/900E
69