Enjoying Music Or Videos With The Tx-Nr900/900E; Basic Operation; To Change The Display Of The Input Source From Tape To Md - Onkyo TX-NR900E Instruction Manual

Enjoying music or videos with the TX-NR900/900E

STANDBY/ON
STANDBY
POWER
ON OFF
AUDIO
SELECTOR
PURE AUDIO UPSAMPLING
PHONES
REC OUT
ZONE 2 LEVEL
Though the TX-NR900/900E is often used to listen to the radio, it
does not show you its true ability until it is used to play music or
watch videos, DVDs, and the like. The TX-NR900/900E has the
latest and most state-of-the-art features to play back today's
technologies with the utmost in fidelity and power. From a two-
speaker system to a seven-speaker system, you are assured a sound
space that you can always enjoy.
To ensure the proper sound space, you must first perform the
speaker setup settings. These settings allow you to set the type of
speakers you are using, the distance that they are located from the
listening position, and the individual speaker volumes. For more
details, see Speaker Setup Sub-menu of the Setup Menu on page 48.

Basic operation

If you want to perform these operations using the remote controller,
first press the RCVR button.
1. Press the input source button (or INPUT SELECTOR
button on the remote controller) that corresponds to
the source to which you want to listen.
TX-NR900/900E
VIDEO 1 VIDEO 2 VIDEO 3 VIDEO
DVD
Remote controller
2. Turn on the corresponding component and play the
media.
3. Adjust the volume.
TX-NR900/900E
MASTER VOLUME
Input source buttons
ZONE 2 ( GRN )
REC ( RED ) 1 2 3 4 5
DVD VIDEO VIDEO VIDEO VIDEO VIDEO TAPE TUNER PHONO C D NET AUDIO
DISPL AY
VCR 1 VCR 2
ZONE 2 OFF STEREO SURROUND THX DSP RT/ PTY/ TP MEMORY FM MODE SETUP ENTER RETURN
CLEAR TUNING PRESET
S VIDEO
DIGITAL
TAPE
4 VIDEO 5 TAPE
TUNER PHONO C D
Remote controller
MASTER VOLUME
RCVR
MASTER VOLUME
VIDEO 5 INPUT
VIDEO L AUDIO R
Adjusting the main volume adjusts the volume level of all the
speakers connected to the TX-NR900/900E together. If
headphones are connected, this also adjusts the volume heard
from the headphone speakers. To adjust the volume, either press
the VOL buttons on the remote controller or turn the
MASTER VOLUME dial. To increase the volume, turn the dial
clockwise; to decrease the volume, turn the dial
counterclockwise. The volume can be set to 0 to 100 (or –∞, –81
to +18 dB).
To change the display of the input source from
TAPE to MD
If you connected an MD recorder to the TAPE jack on the TX-
NR900/900E, you can have "MD" appear when the TAPE source
button is pressed.
Changing the display:
Press and hold down the TAPE source button until the display
changes from TAPE to MD (approx. 3 seconds).
NET AUDIO
To return the display to its original setting, perform the same
procedure.
VOL /
INPUT
SELECTOR
buttons
TAPE
31