Listening To Radio Broadcasts; Tuning Into A Radio Station; Listening To A Stereo Radio Station (Fm Mode) - Onkyo TX-NR900E Instruction Manual

Onkyo corporation av receiver instructions manual tx-nr900, tx-nr900e
Hide thumbs Also See for TX-NR900E:
Table of Contents

Advertisement

Listening to Radio Broadcasts

One of the features of the TX-NR900/900E that is most frequently
used is its ability to play FM and AM broadcast radio stations. The
TX-NR900/900E provides a number of listening modes perfect for
listening to the radio and getting the most out of your audio system.
Also, by presetting radio stations that you listen to frequently, you
can select them easily by pressing the CH
controller.

Tuning into a radio station

1. Press the TUNER input source button.
Each time you press the TUNER button, the
input source changes between AM and FM.
2. Using the TUNING
on the front panel, tune into the
station you desire.
Auto mode
Band
Frequency
• The tuner frequency changes in 100-kHz (50-kHz)
increments for FM and 10-kHz (or 9-kHz) increments for
AM.
• You can press the TUNING
more than 0.5 seconds to scan for an FM station in the
direction of the button you pressed (FM auto tuning mode).
After you release the button and a station is received in stereo,
the scanning stops.
• The European model allows you to receive RDS broadcasts.
See pages 38 and 39 for a more information regarding turning
into RDS broadcasts.
36
STANDBY/ON
STANDBY
POWER
ON
OFF
ZONE
2
(
GRN
REC (
RED
AUDIO
SELECTOR
PURE AUDIO
UPSAMPLING
PHONES
2
REC OUT
ZONE
ZONE
2
LEVEL
button on the remote
TUNER
and
buttons
Tuned in stereo
"FM STEREO"
(Lights red)
or
button continuously for
TUNER
)
)
DVD
VIDEO
1
VIDEO
2
VIDEO
3
VIDEO
4
VIDEO
5
TAPE
TUNER
PHONO
C D
NET AUDIO
DISPL AY
VCR
1
VCR
2
OFF
STEREO SURROUND
THX
DSP
RT/ PTY/ TP MEMORY
FM MODE
SETUP
ENTER
RETURN
CLEAR
TUNING
PRESET
DIGITAL
S VIDEO
FM MODE TUNING
/

Listening to a stereo radio station (FM mode)

When you tune into a radio station,
indicator appears in the display. If you tune into
an FM station in stereo, then "FM STEREO"
appears. If the signal is weak, it may be
impossible to tune into the station in stereo. In
such a case, press the FM MODE button on the
front panel. The AUTO indication disappears
and the radio station is output in the monaural
mode. To return to stereo, press the FM MODE
button again. "AUTO" appears. Some inter-
station noise may be heard, but the sound will
not cut in and out as it would if stereo was
selected.
TUNING
MASTER VOLUME
VIDEO
5
INPUT
VIDEO
L
AUDIO
R
TUNED
FM MODE

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tx-nr900

Table of Contents