Table of Contents
Advertisement
5. Tighten the flange nuts and check the operation of the
seat.
6. When mounting a standard seat to machine, a seat stop
(Fig. 3) must be installed as follows:
A. Move seat forward.
B. Remove capscrew and nut securing water separator
bracket to underside of skirt.
C. Using capscrew and nut removed and a 5/16 x 1"
capscrew and nut supplied in loose parts, secure the
seat stop and water separator to under side of skirt
with (2) capscrews and locknuts. Position stop as
shown in figure 3.
1
Figure 3
1. Seat stop
Adjusting the Rear Carrier
Frame Height
1. Slide the rear carrier frame onto the rear lift arm pivot
rod (Fig. 4). Do not install the carrier frame to the
cutting unit at this time.
2
2. Water separator
15
3
2
4
Figure 4
1. Rear carrier frame
2. Pivot rod
2. Raise the lift arms and carrier frame fully.
3. Press down on one end of the carrier frame until the up
stop on the opposite end contacts the underside of the
foot step (Fig. 4). The distance between the up stop and
the underside of the foot step, on the end pressed down,
should be approximately 1/4 in. (6 mm). If the distance
is not 1/4 in. (6 mm), an adjustment to the lift cylinder
is required. If the distance is correct, remove the carrier
frame and proceed with the setup instructions.
4. If an adjustment to the lift cylinder is required, proceed
as follows:
A. Remove the clevis pin securing the rod end of the
lift cylinder to the lift arm (Fig. 4).
B. Loosen the hex nut securing the clevis to the
cylinder rod.
C. Rotate the clevis end in or out until 1/4 in. (6 mm)
clearance is attained. Check the adjustment and
repeat steps 2–3 as required.
D. Tighten the hex nut and connect the cylinder rod end
to the lift arm (Fig. 4).
Mounting the Carrier Frames to
the Cutting Units
1. Remove the cutting units from the cartons. Adjust them
per the Cutting Unit Operator's Manual.
1
3
3. Up stop
4. Lift cylinder
Advertisement
Table of Contents
