Checking The Deck Front-To-Rear Pitch; Changing The Deck Front-To-Rear Pitch; Checking The Deck Side-To-Side Leveling - Toro 30335 Operator's Manual

Checking the Deck
Front-to-Rear Pitch
1. Check the tire pressure on both deck and traction unit.
2. Position one blade front-to-rear (Fig. 56). Measure at
"C" and "D" locations (Fig. 56) from a level surface to
the cutting edge of the blade tips (Fig. 57).
3. The mower blade should be 1/4 in. (6 mm) lower in
front "C" than in the rear "D". Rotate blades and
repeat for other blades. If it is not correct, proceed to
Changing the Deck Front–to–Rear Pitch.
Figure 56
Figure 57
Changing the Deck
Front-to-Rear Pitch
Changing the front–to–rear pitch is done by adjusting the
front height–of–cut posts.
Changing the Deck Front–to–Rear Pitch
by Adjusting Front Height–of–Cut Posts
1. To change the front-to-rear pitch, the front
height–of–cut posts can be adjusted (Fig. 58).
2. To raise the front of the deck, loosen jam nut and
rotate the front pin clockwise (Fig. 58).
3. To lower the front of the deck, loosen jam nut and
rotate the front pin counter clockwise (Fig. 58).
1. Caster Wheel
2. Carrier Frame
3. Front height–of–cut pins
m–1078
4. Position one blade front-to-rear (Fig. 56). Measure at
"C" and "D" locations (Fig. 56) from a level surface to
the cutting edge of the blade tips (Fig. 57).
5. Check the side-to-side leveling of the cutting unit.
Checking the Deck
Side-to-Side Leveling
1. Check the tire pressure on both deck and traction unit.
m–1087
2. Position the blades side-to-side (Fig. 59). Measure at
"A" and "B" locations (Fig. 59) from a level surface to
the cutting edge of blade tips (Fig. 60).
3. The difference between measurements "A" and "B"
should be no more than 1/4 in. (6 mm).
42
3
2
4
5 1
Figure 58
4. Jam nut
5. Ball joint
m–5231