Checking The Deck Side-To-Side Leveling; Changing The Side-To-Side Leveling; Matching Height Of Cut - Toro 30438 Operator's Manual

MEASURE FROM
CUTTING EDGE TO A
LEVEL SURFACE
Figure 59
Changing the Deck
Front-to-Rear Pitch
Changing the front–to–rear pitch is done by adjusting the
front height–of–cut posts.
Changing the Deck Front–to–Rear Pitch
by Adjusting Front Height–of–Cut Posts
1. To change the front-to-rear pitch, the front
height–of–cut posts can be adjusted (Fig. 60).
2. To raise the front of the deck, loosen jam nut and rotate
the front pin clockwise (Fig. 60).
3. To lower the front of the deck, loosen jam nut and rotate
the front pin counter clockwise (Fig. 60).
Figure 60
1. Caster Wheel
2. Carrier Frame
3. Front height–of–cut pins
4. Position the blades front-to-rear (Fig. 58). Measure at C
and D locations (Fig. 58) from a level surface to the
cutting edge of the blades (Fig. 59).
5. Check the side-to-side leveling of the cutting unit.
6. Tighten the jam nuts (Fig. 60).
m–2539
3
2
4
5 1 m–6371
4. Jam nut
5. Ball joint
Checking the Deck
Side-to-Side Leveling
1. Check the tire pressure on both deck and traction unit.
2. Position the blades side-to-side (Fig. 61). Measure at A
and B locations (Fig. 61) from a level surface to the
cutting edge of blade tips (Fig. 62).
3. The difference between measurements A and B should
be no more than 1/4 inch (6 mm).
A
Figure 61
MEASURE FROM
CUTTING EDGE TO
A LEVEL SURFACE
Figure 62
Changing the Side-to-Side
Leveling
Changing the side–to–side leveling is done by adjusting tire
pressure.
Changing the Side–to–Side Leveling with
Tire Pressure
1. Change the tire pressure on both deck and traction unit.
Do this to the corresponding side that needs adjustment.
2. Recheck the front-to-rear pitch and side to side leveling
of the cutting unit.
40
Front
B
m–2550
m–1078