Drive System Maintenance; Servicing The Tracks - Toro 22333 Operator's Manual

disconnect the charger leads from the battery
posts (Figure 39).
5. Replace the battery cover.
Servicing the Fuses
The electrical system is protected by fuses. It
requires no maintenance; however, if a fuse blows,
check the component/circuit for a malfunction or
a short. Figure 40 illustrates the fuse block and
identifies the fuse positions.
Figure 40
1. 30 amp. fuse—main circuit 3. 10 amp fuse—control
2. Empty
Note: If the traction unit will not start, either
the main circuit or control panel/relay fuse could
be blown.
To access the fuses, you must remove the fuse
panel, as follows:
1. Stop the engine and remove the key.
2. Raise the hood.
3. Pull the hairpin cotter from the end of the
hood prop-rod and slide the prop rod out of
the retaining brackets (Figure 41).
panel/relay
4. Open position for optional
accessories
Figure 41
1. Prop-rod
4. Remove the 4 screws securing the fuse panel
and then pull the panel out and up to remove
it (Figure 42).
Figure 42
1. Fuse panel
5. Check the fuses.
6. Install the fuse panel using the 4 screws
removed previously.
7. Install the prop-rod into the retaining brackets
and secure it with the hairpin cotter.
8. Close the hood.
Drive System
Maintenance

Servicing the Tracks

Cleaning the Tracks
Check the tracks for excessive wear and clean them
periodically. If the tracks are worn, replace them.
37
2. Hairpin cotter
2. Screw