Parking Brake Lever - Toro 22333 Operator's Manual

Figure 11
1. Lower the loader arms
2. Raise the loader arms
3. Tilt the attachment
rearward
By moving the lever to an intermediate position
(such as, forward and left), you can move the
loader arms and tilt the attachment at the same
time.
Loader Valve Lock
The loader valve lock secures the loader
arm/attachment tilt lever so that you cannot push
it forward. This helps to ensure that no one
will accidentally lower the loader arms during
maintenance. Secure the loader arms with the lock
anytime you need to stop the machine with the
loader arms raised.
To set the lock, lift up on it so it clears the hole in
the control panel and swing it to the left in front
of the loader arm lever, pushing it down into the
locked position (Figure 12).
Figure 12
1. Loader valve lock
4. Tilt the attachment forward
5. Detent (Float) position
2. Loader arm/attachment tilt
lever
Auxiliary Hydraulics Lever
To operate a hydraulic attachment in the forward
direction, rotate the auxiliary hydraulics lever
rearward and pull it down to the reference bar
(Figure 13, number 1).
To operate a hydraulic attachment in reverse
direction, rotate the hydraulics lever rearward, then
move it left into the upper slot (Figure 13, number
2).
If you release the lever while in the forward
position, the lever will automatically return to the
neutral position (Figure 13, number 3). If it is in
the reverse position, it will remain there until you
pull it out of the slot.
Figure 13
1. Forward ow hydraulics
2. Reverse ow hydraulics

Parking Brake Lever

To set the parking brake, push the brake lever
forward and to the left and then pull it rearward
(Figure 14).
Note: The traction unit may roll slightly before
the brakes engage in the drive sprocket.
17
3. Neutral