Starting And Stopping The Engine; Stopping The Traction Unit - Toro 22333 Operator's Manual

2. Open the hood.
3. Open the air bleed screw on the fuel injection
pump (Figure 22).
Figure 22
1. Fuel injection pump bleed screw
4. Turn the key in the ignition switch to the On
position. The electric fuel pump will begin
operation, thereby forcing air out around
the air bleed screw. Leave the key in the On
position until a solid stream of fuel flows out
around the screw.
5. Tighten the screw and turn the key to the Off
position.
Note: Normally, the engine should start after the
above bleeding procedures are followed. However,
if engine does not start, air may be trapped
between injection pump and injectors; contact
your Authorized Service Dealer.
Starting and Stopping the
Engine
Starting the Engine
1. Ensure that the auxiliary hydraulics lever is in
neutral.
2. Move the throttle lever midway between slow
(turtle) and fast (rabbit) positions.
3. Turn the ignition key to the Run position.
4. Press the glow plug switch and hold it for 10
seconds.
5. Turn the ignition key to the Start position.
When the engines starts, release the key.
Important: Do not engage the starter
for more than 10 seconds at a time. If the
engine fails to start, allow a 30 second
cool-down period between attempts.
Failure to follow these instructions can
burn out the starter motor.
6. Move the throttle lever to desired setting.
Important: If the engine is run at high
speeds when the hydraulic system is cold
(i.e., when the ambient air temperature is
near freezing or lower), hydraulic system
damage could occur. When starting the
engine in cold conditions, allow the engine
to run in the middle throttle position for
2 to 5 minutes before moving the throttle
to fast (rabbit).
Note: If outdoor temperature is below
freezing, store the traction unit in a garage to
keep it warmer and aid in starting.
Stopping the Engine
1. Move the throttle lever to the slow (turtle)
position.
2. Lower the loader arms to the ground.
3. Turn the ignition key off.
Note: If the engine has been working hard or
is hot, let it idle for a minute before turning
the ignition key off. This helps cool the engine
before it is stopped. In an emergency, the
engine may be stopped immediately.

Stopping the Traction Unit

To stop the traction unit, release the traction
control, move the throttle lever to slow (turtle),
lower loader arms to the ground, and stop the
engine. Set the parking brake and remove the key.
A child or untrained bystander could attempt
to operate the traction unit and be injured.
Remove the key from the switch when
leaving the traction unit, even if just for a
few seconds.
25