Closing The Rear Access Cover; Removing The Side Screens; Installing The Side Screens; Lubrication - Toro 22333 Operator's Manual

Figure 29
1. Hand knob
2. Tilt the rear access cover down and remove to
access the internal components (Figure 29).
Closing the Rear Access
Cover
1. Move the rear access cover in place over the
back of the traction unit making sure the tabs
line up in the slots.
2. Push the access cover forward, lining up the
hand knob screws with the threaded holes in
the machine.
3. Screw the hand knobs tight to secure the rear
access cover in place.

Removing the Side Screens

1. Open the hood.
2. Slide the side screens (Figure 30) up and out of
the slots in the front screen and frame.
Figure 30
1. Side screen

Installing the Side Screens

Slide the side screens into place in the slots in the
front screen and frame.

Lubrication

Greasing the Traction Unit

Grease all pivot joints every 8 operating hours and
immediately after every washing.
Grease Type: General-purpose grease.
1. Lower the loader arms and stop the engine.
Remove the key.
2. Clean the grease fittings with a rag.
3. Connect a grease gun to each fitting (Figure 31
and Figure 32).
31