Servicing The Engine Oil - Toro 22333 Operator's Manual

Important: To prevent engine damage,
always operate the engine with both air
filters and cover installed.
10. Carefully slide the primary filter over the safety
filter (Figure 33). Ensure that it is fully seated
by pushing on the outer rim of the filter while
installing it.
Important: Do not press on the soft
inside area of the filter.
11. Install the air cleaner cover with the side
indicated as UP facing up and secure the
latches (Figure 33).
12. Close the hood.

Servicing the Engine Oil

Change oil and the oil filter after the first 50
operating hours. Change the oil every 100
operating hours and the oil filter ever 200
operating hours thereafter..
Note: Change oil and oil filter more frequently
when operating conditions are extremely dusty or
sandy.
Oil Type: Detergent diesel engine oil (API service
CH-4 or higher)
Crankcase Capacity: w/filter, 0.98 US gallons (3.7
l)
Viscosity: See table below
Figure 34
Changing the Oil
1. Start the engine and let it run for five minutes.
This warms the oil so it drains better.
2. Park the traction unit so that the drain side is
slightly lower than the opposite side to ensure
that the oil drains completely.
3. Lower the loader arms, set the parking brake,
stop the engine, and remove the key.
Components will be hot if the traction
unit has been running. If you touch hot
components you may be burned.
Allow the traction unit to cool before
performing maintenance or touching
components under the hood.
4. Remove the drain plug (Figure 35).
Figure 35
1. Oil drain plug
5. When the oil has drained completely, replace
the plug.
Note: Dispose of the used oil at a certified
recycling center.
6. Remove the oil fill cap and slowly pour
approximately 80% of the specified amount of
oil in through the valve cover.
7. Check the oil level; refer to Checking the
Engine Oil Level in Operation, page 21.
33