Stability Data - Toro 22333 Operator's Manual

Stability Data

The following tables list the maximum slope recommended for the traction unit in the positions listed in
the tables. Slopes over the listed degree may cause the traction unit to become unstable. The data in the
tables assume that the loader arms are fully lowered; raised arms may affect the stability.
In each attachment manual is a set of three stability ratings, one for each hill position. To determine the
maximum slope you can traverse with the attachment installed, find the degree of slope that corresponds
to the stability ratings of the attachment. Example: If the attachment installed on a TX model 22319
traction unit has a Front Uphill rating of B, a Rear Uphill rating of D, and a Side Uphill rating of C,
then you could drive forward up a 19° slope, rearward up a 12° slope, or sideways on a 14° slope, as
listed in the following table.
Model 22333
Conguration
Traction unit without attachment
Traction unit with an attachment rated with one of the following
stability ratings for each slope position:*
A
B
C
D
E
Model 22334
Conguration
Traction unit without attachment
Traction unit with an attachment rated with one of the following
stability ratings for each slope position:*
A
B
C
D
E
Maximum Recommended Slope when
Operating with:
Front Uphill
11°
25°
19°
16°
10°
5°
Maximum Recommended Slope when
Operating with:
Front Uphill
12°
25°
22°
18°
10°
5°
20
Rear Uphill Side Uphill
21° 19°
25° 20°
19° 18°
15° 14°
12° 9°
5° 5°
Rear Uphill Side Uphill
19° 21°
25° 23°
22° 20°
16° 14°
10° 10°
5° 5°