Table of Contents
Advertisement
4.
Reconnect return spring to clutch lever.
5.
Verify that rear edge of clutch pedal is 14 cm ±
3mm (5.5" ± 0.12") from the top of the floor plate
diamond pattern. If dimension is not attained,
adjust clutch pedal up stop.
Note: Clutch free play should never be less than
1.9 cm (0.75").
6.
Tighten jam nuts after adjustment has been
attained.
7.
Recheck clutch safety switch adjustment (Fig.
55). Engine must not crank unless clutch pedal is
2.9cm ± 6mm (1.25" ± .25") from floor. If an
adjustment is required, loosen switch jam nuts
and adjust up or down.
3
1. Clutch cable
2. Jam nuts
3. Return spring
4. Ball joint
1. Clutch switch
Adjusting Parking Brake (Fig. 56)
Check adjustment every 200 hours.
1.
Loosen the set screw securing knob to parking
brake lever.
1
4
Figure 54
1
Figure 55
2.
Rotate knob until a force of 47–61 Nm (35–45
lbs.) for 2-wd models and 61–75 Nm (45–55 lbs.)
for 4-wd models is required to actuate lever.
3.
Tighten set screw after adjustment has been
attained.
2
1. Parking brake lever 2 Knob
3. Set screw
Adjusting Shift Cables (Fig. 57)
Check adjustment every 200 hours.
1.
Move shift lever to Neutral position.
2.
Remove clevis pins securing shift cables to
transaxle shift arms.
2
3.
Loosen clevis jam nuts and adjust each clevis so
cable free play is equal forward and backward
relative to hole in transaxle shift arm (With
transaxle lever free play taken up in same
direction).
4.
Reinstall clevis pins and tighten jam nuts after
adjustments have been attained.
Adjusting the High-Low Cable
(Fig. 57)
Check adjustment every 200 hours.
1.
Remove clevis pin securing High-Low cable to
transaxle.
2.
Loosen clevis jam nut and adjust clevis so clevis
hole aligns with hole in transaxle bracket.
3.
Reinstall clevis pin and tighten jam nut after
adjustment has been attained.
46
3
1
Figure 56
Advertisement
Table of Contents
