Table of Contents
Advertisement
4.
Install reserve tank cap.
3
2
1. Reserve tank
2. Cold line
3. Hot line
Check Hydraulic Fluid (Fig. 14)
The transaxle reservoir is filled with Dextron III ATF.
Check level before engine is first started and every 8
hours or daily, thereafter. Capacity of system is 7.1 l
(7.5 qts.).
1.
Position the vehicle on a level surface.
2.
Clean area around dipstick.
3.
Unscrew dipstick from top of transaxle and wipe
it with a clean cloth.
1. Dip stick
4.
Screw dipstick into transaxle and make sure it is
seated fully. Unscrew dipstick and check fluid
level. Fluid should be up to top of flat portion of
dipstick. If level is low, add enough fluid to
achieve the proper level.
Figure 13
1
Figure 14
Check Front Differential Oil
Four-Wheel Drive Model Only (Fig. 15)
1
The differential is filled with 10W30 oil. Check level
of oil every 100 hours or monthly. Capacity of system
is 0.9 l (1 qt.).
1.
Position the vehicle on a level surface.
2.
Clean area around fill/check plug on side of
differential.
1. Front differential
2. Fill/check plug
3. Drain plug
3.
Remove fill/check plug and check level of oil. Oil
should be up to hole. If oil is low, add 10W30 oil.
4.
Re-install fill/check plug.
Check Torque of Wheel Nuts
Failure to maintain proper torque could result in
failure or loss of wheel and may result in
personal injury. Torque front and rear wheel
nuts to 61–88 Nm (45–65 ft-lb) after 1 to 4
hours of operation and again after 10 hours of
operation and every 200 hours thereafter.
Check Tire Pressure
Check tire pressure every 8 hours or daily to assure
proper levels.
Maximum air pressure in front tires is 138 kPa (20 psi)
and rear tires is 124 kPa (18 psi).
18
Figure 15
WARNING
Advertisement
Table of Contents
