Setting The Sensor Controller To Obtain Sensing Information From; Setting Assignments - Omron ZS-MDC User Manual

Section 3

Setting the Sensor Controller to Obtain Sensing Information from

Setting the Sensor Controller to Obtain Sensing Information from
Set which gang-mounted Sensor Controller to obtain information from, and which logic
operations are to be performed on that information.

Setting Assignments

Assign the channel to perform logic operation on.
FUNMode-[SENSING]-[SEL CH]
Setting
INPUT A (input A)
INPUT B (input B)
INPUT C (input C)
INPUT D (input D)
INPUT E (input E)
INPUT F (input F)
INPUT G (input G)
INPUT H (input H)
INPUT I (input I)
ZS-MDC
3-14
User's Manual
Assigns the target Sensor Controller to input A.
Range: None, 1CH onwards (largest CH of gang-mounted Sensor Controllers)
(default: 1CH. Note that range becomes "None" if 1CH does not exist.)
Assigns the target Sensor Controller to input B.
Range: None, 1CH onwards (largest CH of gang-mounted Sensor Controllers)
(default: 2CH. Note that range becomes "None" if 2CH does not exist.)
Assigns the target Sensor Controller to input C.
Range: None, 1CH onwards (largest CH of gang-mounted Sensor Controllers)
(default: 3CH. Note that range becomes"None" if 3CH does not exist.)
Assigns the target Sensor Controller to input D.
Range: None, 1CH onwards (largest CH of gang-mounted Sensor Controllers)
(default: 4CH. Note that range becomes "None" if 4CH does not exist.)
Assigns the target Sensor Controller to input E.
Range: None, 1CH onwards (largest CH of gang-mounted Sensor Controllers)
(default: 5CH. Note that range becomes "None" if 5CH does not exist.)
Assigns the target Sensor Controller to input F.
Range: None, 1CH onwards (largest CH of gang-mounted Sensor Controllers)
(default: 6CH. Note that range becomes "None" if 6CH does not exist.)
Assigns the target Sensor Controller to input G.
Range: None, 1CH onwards (largest CH of gang-mounted Sensor Controllers)
(default: 7CH. Note that range becomes "None" if 7CH does not exist.)
Assigns the target Sensor Controller to input H.
Range: None, 1CH onwards (largest CH of gang-mounted Sensor Controllers)
(default: 8CH. Note that range becomes "None" if 8CH does not exist.)
Assigns the target Sensor Controller to input I.
Range: None, 1CH onwards (largest CH of gang-mounted Sensor Controllers)
(default: 9CH. Note that range becomes "None" if 9CH does not exist.)
Description