About Setup; Basic Knowledge For Operation - Omron ZS-MDC User Manual

Smart sensor multi-controller

Hide thumbs Also See for ZS-MDC:

Table of Contents

Section 3

About Setup

The ZS-MDC Series can be set up on the Multi-Controller or on the SmartMonitor Zero

software utility.

This manual describes setup on the Multi-Controller.

For details on how to set up the ZS-L Series on SmartMonitor Zero, refer to Help

contained on the SmartMonitor Zero CD-ROM.

The following describes basic operation of the Multi-Controller before you set up the ZS-L

Series.

■ Switching Modes

The ZS-MDC has the following 3 operating modes.Switch to the desired mode before

you start operation.

To switch the operating mode, use the Mode Switch.

FUN Mode

RUN mode

TEACH Mode

When you switch the operating mode after changing the measurement conditions, you will be

prompted to save the settings. Save the settings as required. If you turn off the Multi-Controller with-

out saving these settings, the newly set measurement conditions will be cleared from memory. You

can also save all the settings later on.

ZS-MDC

3-4

User's Manual

Mode

Mode for setting the measurement conditions

Normal operating mode

This mode is for setting the judgment threshold values.

Sensor Controller User's Manual, Section 3 Setup

TEACH

FUN

RUN

Description

Table of Contents