Mount Cutting Units - Toro 03200 Reelmaster 3100-D Operator's Manual

3. Position rear carrier frame (Fig. 17) onto rear cutting
unit, aligning mounting holes with mounting links as
shown in figure 18.
Figure 17
1. Rear carrier frame
4. Secure each mounting link to carrier frame with a
3/8–16 x 2–1/4" lg capscrew, (2) flatwashers and a
locknut, as shown in figure 18. Position a washer on
each side of link when mounting. Torque to 31 ft–lb.
2
FRONT
Figure 18
1. Carrier frame
2. Mounting link

Mount Cutting Units

1. Slide a thrust washer onto each front lift arm pivot rod.
2. Slide cutting unit carrier frame onto pivot rod and
secure with a lynch pin (Fig. 19).
1
1
3
3. Plug
18
Note: On rear cutting unit, thrust washer to be positioned
between rear of carrier frame and lynch pin.
2
1
Figure 19
1. Thrust washer
2. Carrier frame
3. Grease all lift arm and carrier frame pivot points.
Important
Make sure hoses are free of twists or
sharp bends and rear cutting unit hoses are routed as
shown in Fig. 20. Raise cutting units and shift them to
the left (Model 03201 only). Rear cutting unit hoses
must not contact traction cable bracket. Re–position
fittings and / or hoses, if required.
Figure 20
4. Route a tipper chain up thru slot in end of each carrier
frame. Secure tipper chain to top of carrier frame with a
capscrew, washer and locknut (Fig. 21).
3
3. Lynch pin