Install Seat - Toro 03200 Reelmaster 3100-D Operator's Manual

must not contact battery cover. Slide the rubber boot
over the positive terminal to prevent possible short–out
from occurring.
Warning
Connecting cables to the wrong post could
damage the electrical system and result in
personal injury.
2
Figure 3
1. Positive (+) battery cable
Important
If battery is ever removed, make sure
battery clamp bolts are reinstalled with bolt heads
positioned on bottom side and nuts on top side. If clamp
bolts are reversed, they may interfere with hard lines when
shifting cutting units.
9. Coat both battery connections with Grafo 112X (skin
over) grease, Toro Part No. 505–47, petroleum jelly or
light grease to prevent corrosion and slide rubber boot
over positive terminal.
10. Install battery cover.

Install Seat

The Reelmaster 3100 is shipped without the seat assembly.
Deluxe Seat Kit, Model 03225 or Standard Seat Kit, Model
03224, must be installed as follows:
1. Remove capscrews securing seat mounting straps to
traction unit frame (Fig. 4).
2. Secure seat mounting straps to seat adjusters with (4)
flange nuts (standard seat) or (4) capscrews, flat
washers and flange nuts (deluxe seat). Mounting
fasteners supplied with seat kit loose parts.
1
2. Negative (–) battery cable
1. Seat mounting strap (2)
3. Install seat belt to holes on each side of seat with (2)
bolts and lockwashers (standard seat) or (2) bolts and
locknuts (deluxe seat). All mounting fasteners supplied
with seat kit loose parts.
1
2
1. Standard seat
2. Seat adjusters
4. Position seat and seat straps on frame aligning
mounting holes.
5. Route seat switch wire under right hand seat strap and
connect to appropriate seat switch connector on harness.
6. On deluxe seat only, route unused seat switch connector
back under seat strap and secure both wires to rear most
hole in seat strap (Fig. 6) with a cable tie (cable tie
supplied with seat kit).
14
1
Figure 4
3
Figure 5
3. Seat belt