Table of Contents
Advertisement
Counter1End Event
Counter2End Event
Timer1 Active
Timer2 Active
Counter1 Active
Counter2 Active
Trigger Input Line Activation
Rising Edge
Falling Edge
Any Edge
Level High
Level Low
Trigger Overlap
Off
Readout
Previous Line
Trigger Delay
Trigger Delay Source
Internal Clock
Line Trigger Signal
Line Trigger Input Frequency
Rotary Encoder Output Mode
Position
Motion
Linea GigE Series Camera
Counter1End
Counter2End
Timer1Active
Timer2Active
Counter1Active
Counter1Active
TriggerActivation
RisingEdge
FallingEdge
AnyEdge
LevelHigh
LevelLow
TriggerOverlap
ReadOut
previousLine
TriggerDelay
triggerDelaySource
InternalClock
lineTriggerSignal
lineTriggerInputFrequency
rotaryEncoderOutputMode
Position
Motion
Select the Counter1End Event as the internal~
trigger source.
Select the Counter2End Event as the internal
trigger source.
Select the Timer1Active signal as the internal
trigger source.
Select the Timer2Actuve signal as the internal
trigger source.
Select the Counter1Active signal as the internal
trigger source.
Select the Counter2Active signal as the internal
trigger source.
Select the activation mode for the selected Input
Line trigger source. This is applicable only for
external line input lines.
The trigger is considered valid on the rising edge
of the line source signal (after any processing by
the line inverter module).
The trigger is considered valid on the falling edge.
The trigger is considered valid on any edge ...
The trigger is considered valid as long as the level
of the source signal is high.
The trigger is considered valid as long as the level
of the source signal is low.
Specifies if a trigger overlap is permitted with the
Active Frame or Active Line signal. This defines if a
new valid trigger will be accepted (or latched) for
a new frame or line.
Off
No trigger overlap is permitted. (Frame Trigger).
Trigger is accepted immediately after the
exposure period (readout). (Line Trigger)
Overlapped exposures must not end before
readout of the previous exposure.
Trigger is accepted (latched) at any time during
the capture of the previous line. (Line Trigger)
Only frame triggers can be delayed. Specifies the
delay to apply after receiving the trigger and
before activating triggerEvent. The delay can be
set in microseconds or in line trigger signals. The
delayer can buffer and apply the specified delay to
a maximum of 128 frame trigger pulses
simultaneously. Any additional triggers will be lost
if the trigger delayer buffer is full.
Sets the event that increments the trigger delay
counter.
The delay counter increments on each
microsecond tick of the device internal Clock.
The delay counter increments on each pulse
received by the line trigger module. The delay
counter increments even if the pulse is rejected
by the line trigger module.
Current line frequency measured by the camera.
Specifies the conditions for the Rotary Encoder
interface to generate a valid Encoder output
signal.
Triggers are generated at all new position
increments in the selected direction. If the
encoder reverses no trigger events are generated
until it has again passed the position where the
reversal started.
The triggers are generated for all motion
increments in either direction.
1.00
Beginner
1.00
Beginner
1.00
Beginner
1.00
DFNC
Beginner
1.00
Beginner
1.00
Expert
DFNC
Operational Reference • 37
Advertisement
Table of Contents
