Teledyne Linea GigE 2K User Manual page 31

Save Configuration
Device Built-In Self Test
Device Built-In Self Test
Status
Passed
Firmware update failed
FPGA Cyclic Redundancy
Check Failed
Unexpected Error
Device Built-In Self Test
Status All
Device Reset
Device Temperature
Selector
FPGA Board
Device Temperature
DeviceID
Calibration Date
Device Acquisition Type
Sensor
Device TL Type
GigE Vision
Device TL Version Major
Device TL Version Minor
Power-up Configuration
Selector
None
Factory Setting
UserSet1
to
UserSet4
DFNC Major Rev
DFNC Minor Rev
SFNC Major Rev
Linea GigE Series Camera
UserSetSave
deviceBIST
deviceBISTStatus
Passed
FirmwareUpdateFailure
FPGA_CRC_Failure
Unexpected_Error
deviceBISTStatusAll
DeviceReset
DeviceTemperatureSelector
FPGABoard
DeviceTemperature
DeviceID
deviceCalibrationDateRaw
deviceAcquisitionType
Sensor
DeviceTLType
GigEVision
DeviceTLVersionMajor
DeviceTLVersionMinor
UserSetDefaultSelector
None
Default
UserSet1
to
UserSet4
deviceDFNCVersionMajor
deviceDFNCVersionMinor
DeviceSFNCVersionMajor
Saves the current camera configuration to the user set
specified by the User Set Selector feature. The user
sets are located on the camera in non-volatile
memory. (W)
Command to perform an internal test which will
determine the device status. (W)
Return the status of the device Built-In Self test.
Possible return values are device-specific.
No failure detected
Last firmware update operation failed.
FPGA cyclic redundancy check failed.
Switched to recovery mode due to unexpected
software error.
Return the status of the device Built-In Self Test as a
bitfield. The meaning for each bit is device-specific.
Resets the device to its power up state. (W)
Select the source where the temperature is read.
Read FPGA Board temperature
The temperature of the selected source in degrees
Celsius
Displays the device's factory set serial number.
Date when the camera was calibrated.
Displays the Device Acquisition Type of the product.
(RO)
The device gets its data directly from a sensor.
Transport Layer type of the device.
GigE Vision Transport Layer
Major version of the device's Transport Layer.
Minor version of the device's Transport Layer.
Selects the camera configuration set to load and make
active on camera power-up or reset. The camera
configuration sets are stored in camera non-volatile
memory. (RW)
Keep Internal configuration.
Select the Factory Setting values as the Power-up
Configuration.
Select the user defined configuration as the Power-up
Configuration.
Major revision of Dalsa Feature Naming Convention
which was used to create the device's XML. (RO)
Minor revision of Dalsa Feature Naming Convention
which was used to create the device's XML. (RO)
Major Version of the Standard Features Naming
Convention which was used to create the device's
XML. (RO)
1.00
Beginner
1.00
DFNC
Beginner
1.00
Beginner
1.00
DFNC
Beginner
1.00
Beginner
1.00
Beginner
1.00
Beginner
1.00
Invisible
1.00
DFNC
Invisible
1.00
DFNC
Invisible
1.00
Invisible
1.00
Invisible
1.00
Invisible
1.00
Invisible
1.00
DFNC
Invisible
1.00
DFNC
Invisible
1.00
Invisible
Operational Reference • 29