Setup] Menu ([Control Menu] Options) - Canon LBP7660Cdn Manual

[Setup] Menu ([Control Menu] Options)

NOTE
Table description
Bold values in the table indicate the default settings.
After changing the setting items with "*1", cycle the power of the printer or perform a hard reset to make the
settings effective.
The setting items or setting values with "*2" may not be displayed depending on the availability of the optional
accessories and other settings.
Setting Item
[Sleep Mode]
[Sleep Even if Error]
[Sleep Migration
Time]
[Timer Settings]
[Wake Up Timer]
[Wake Up Time]
[Auto Reset Time]
[Sleep Mode
Timer]
[Sleep Mode
Time]
[Calibration Timer]
[Calibration Time]
[Warning Step]
[Toner Cart.
Setting Value
[High (Deep Sleep)], [Mid (Printer Sleep)]
[Off], [On]
[5 minutes], [10 minutes], [15 minutes], [30
minutes], [60 minutes]
[Off], [On]
00:00 to 12:00 to 23:59
[Off], [10 seconds], [20 seconds], [30
seconds], [40 seconds], [50 seconds], [1
minute], [2 minutes], [3 minutes], [4
minutes], [5 minutes], [6 minutes], [7 minutes],
[8 minutes], [9 minutes]
[Off], [On]
00:00 to 12:00 to 23:59
[Off], [On]
00:00 to 12:00 to 23:59
[Continue Printing], [Stop Printing]
Setting
Set the sleep mode.
"Sleep Mode"
Set sleep modes (printer sleep mode and
deep sleep mode) to cancel automatically.
"Sleep Mode"
Specifies whether one of the following
transitions is to take place when no key
operation has been performed in a particular
screen.
A transition to the MEAP authentication
screen (LBP7680Cx only)
A transition to the ready status screen
and the screen for using MEAP
applications (LBP7680Cx only)
A transition from offline status to online
status
When no key operation has been
performed during a job processing
session, this function is also executed
depending on the current screen or
current position in a menu.
"Online and Offline"
Specifies whether the sleep timer function is
used to put the printer into a sleep mode
(printer sleep mode or deep sleep mode)
when the printer is not used for a certain
time.
"Sleep Mode"
Set whether to run calibration automatically
at set times.
"Specifying Times and Performing
Automatic Calibration"
Specifies whether the printer should continue
or stop printing when <Toner cartridge will
0258-08L