Canon LBP7660Cdn Manual page 397

If the SSL encrypted communication function is not used, this item cannot be set by the Remote
UI. Either enable the SSL encrypted communication function, or set from the control panel using
the following procedure.
a. Press [
[SNMP v. 3] to [On].
b. Set each password using [Auth. Password] from [User Settings 1] to [User Settings 5].
For details on the SSL encrypted communication function, see
7. If [Security Settings] are set to [Authentication Yes/Encryption Yes], set an encrypted password.
Set [Encryption Algorithm] to [DES] or [AES].
[Encryption Enter the password to be used for the encryption function of the encryption
Password]: algorithm. 6 to 16 alphanumeric characters can be entered.
[Confirm]: To confirm the password, enter the entered [Encryption Password] again.
If the SSL encrypted communication function is not used, this item cannot be set by the Remote
UI. Either enable the SSL encrypted communication function, or set from the control panel using
the following procedure.
a. Press [
@ 6HWXS DQG VHOHFW >1HWZRUN@
@ 6HWXS DQG VHOHFW >1HWZRUN@
>6103 Y  6HWWLQJV@ DQG VHW
"Setting Keys and Certificates."
>6103 Y  6HWWLQJV@ DQG VHW