Table of Contents
Advertisement
Precautions with regard to safety
WARNING
POWER
installed near the equipment and shall be easily
accessible when problems occur. If the followings
problems occur, cut off the power supply
immediately.
Continued use of the projector in these conditions will
If foreign objects or water get inside the projector, cut
off the power supply.
If the projector is dropped or the cabinet is broken, cut
off the power supply.
If you notice smoke, strange smells or noise coming
from the projector, cut off the power supply.
Please contact an Authorized Service Center for
repairs, and do not attempt to repair the projector
yourself.
During a thunderstorm, do not touch the projector
or the cable.
Electric shocks can result.
Do not do anything that might damage the power
cord or the power plug.
If the power cord is used while damaged, electric
Do not damage the power cord, make any
it excessively, twist it, pull it, place heavy objects on
top of it or wrap it into a bundle.
Ask an Authorized Service Center to carry out any
repairs to the power cord that might be necessary.
Insert the power plug securely into the wall outlet.
If the plug is not inserted correctly, electric shocks or
overheating will result.
Do not use anything other than the provided power
cord.
Do not use the provided power cord for other
electrical equipment.
Do not use plugs which are damaged or wall outlets
which are coming loose from the wall.
Clean the power plug regularly to prevent it from
becoming covered in dust.
If dust builds up on the power plug, the resulting
humidity can damage the insulation.
If not using the projector for an extended period of
time, pull the power plug out from the wall outlet.
Pull the power plug out from the wall outlet and wipe it
with a dry cloth regularly.
Do not handle the power plug with wet hands.
Failure to observe this will result in electric shocks.
Do not overload the wall outlet.
If the power supply is overloaded (ex., by using too
result.
ON USE/INSTALLATION
Do not place liquid containers on top of the
projector.
electric shocks will result.
If any water gets inside the projector, contact an
Authorized Service Center.
Do not place the projector on soft materials such as
carpets or sponge mats.
Doing so will cause the projector to overheat, which
Do not set up the projector in humid or dusty places
or in places where the projector may come into
Using the projector under such conditions will result
Components deterioration (such as ceiling mount
brackets) may cause the projector which is mounted on
the ceiling to fall down.
Do not install this projector in a place which is
projector or on top of a surface which is sloped or
unstable.
Failure to observe this will cause projector to fall down
or tip over the projector, and severe injury or damage
could result.
Do not place another projector or other heavy
objects on top of the projector.
Failure to observe this will cause the projector to
become unbalanced and fall, which could result in
damage or injury. The projector will be damaged or
deformed.
If installation is not carried out and secured correctly it
can cause injury or accidents, such as electric shocks.
Do not use anything other than an Authorized ceiling
mount bracket.
Do not cover the air inlet port or the air outlet port.
Doing so will cause the projector to overheat, which can
Do not place the projector in narrow, badly ventilated
places such as closets or bookshelves.
Do not place the projector on cloth or papers, as
these materials could be drawn into the air inlet port.
Do not place your hands or other objects close to
the air outlet port.
Doing so will cause burns or damage your hands or
other objects.
Heated air comes out of the air outlet port. Do not
place your hands or face, or objects which cannot
withstand heat close to this port.
ENGLISH
7
Advertisement
Table of Contents
