Table of Contents
Advertisement
Project an image
Preparations
(
page 18, 19) and power cord (
Switch on the power (
Select the input signal and adjust the image.
SELECT THE INPUT SIGNAL
1
Switch on the connected devices.
When playing a connected DVD player, if SIGNAL
SEARCH (DISPLAY OPTION menu) is set to
ON, the input signal is detected and projected
automatically when the projector is switched on.
(
page 37)
Set the INPUT GUIDE (DISPLAY OPTION
ON-SCREEN DISPLAY menu) to DETAILED. If
the projector cannot detect any input signal, the
"Computer connection guide" will be displayed.
(
page 35)
2
Select an input signal.
The image selected with any of the [INPUT
SELECT] button is projected.
NOTE:
Change the settings in the PICTURE menu according to the
connected device for example DVD, video tape, etc., to be
played. (
page 30)
Select the optimum aspect ratio. (
POSITION THE IMAGE
setting up at a new place, you must perform the
following operations.
1
Adjust the vertical angle of the projector.
Place the projector at the right angle from the
screen.
24
ENGLISH
page 20).
page 22) to start projecting.
page 33)
Press the leg adjuster button
the vertical projection angle. Then, adjust the
projected image to the center of the screen.
2
Adjust the projection focus.
Turn the focus ring to adjust the projected image.
NOTE:
If keystone distortion occurs, see KEYSTONE.
(
page 32)
and adjust
Leg adjuster
Focus ring
(FOCUS)
Advertisement
Table of Contents
