Table of Contents
Advertisement
Care and Replacement (continued)
Lamp replacement procedure
When the projector is mounted in the ceiling, do not work directly under the projector or put your face close to the
projector.
Be sure to install the lamp unit and attach the lamp unit cover securely. If they are not securely installed, it may
cause the protection circuit to operate and the power cannot be turned on.
1
Disconnect the power plug from the wall outlet
according to "TURN THE PROJECTOR OFF"
(
page 23)
the bottom if the lamp unit has cooled.
2
Use a Phillips-head screwdriver to loosen the
projector until the screw loosen and remove
the lamp unit cover.
Lamp unit cover screw
S-VIDEO
AUDIO
IN
OUT
N
1
2
VIDEO IN
AUDIO IN
N
Lamp unit cover
3
Use a Phillips-head screwdriver to loosen the
2 lamp unit screws. Pull the used lamp unit
gently from the projector.
Lamp unit screws
48
ENGLISH
4
Lamp unit cover
Rear side
5
6
7
NOTE:
If INITIAL START UP in the PROJECTOR SETUP menu
Top side
is set to ON, the projector starts projecting when the power
cord is connected to a wall outlet. (
8
Handles
sure the unit is installed securely. Tighten the
2 lamp unit screws securely with a Phillips-
head screwdriver.
During insertion, particularly press the
securely.
Lamp unit screws
Attach the lamp unit cover and tighten the
1 lamp unit cover screw securely with a
Phillips-head screwdriver.
Connect the power cord to a wall outlet.
Press [POWER] to begin projection.
MENU
To display the main
menu.
portion
page 39)
To scroll to the
PROJECTOR SETUP
menu.
Advertisement
Table of Contents
