Replacing the processor heat sink
6.3
Replacing the processor heat sink
Ê Open the server as described in
Ê Remove the air duct over the main memory and the processors (see
"Upgrading/replacing the main memory" on page
Ê Loosen the four heat sink screws in a crossover pattern (see
"Replacing the processor" on page
Ê Loosen the heat sink by turning it back and forth and then lift it out.
Ê Clean the upper side of the processor using a lint-free cloth.
Ê Remove the protective cover from the new heat sink.
Ê Place the heat sink on the processor socket (see
processor" on page
Ê Fasten the heat sink by tightening the four screws in a crossover pattern.
Ê Reinstall the air duct over the main memory and the processors (see
"Upgrading/replacing the main memory" on page
42
section "Opening the server" on page
38).
38).
Options Guide
Processors
28).
section
section "Replacing the
28).
RX300 S3
23.
section
section