Installing A Localview Module - Fujitsu PRIMERGY RX300 S3 Options Manual
Hide thumbs
Also See for PRIMERGY RX300 S3:
- User manual (313 pages) ,
- Operating manual (113 pages) ,
- Service supplement manual (59 pages)
Table of Contents
Advertisement
Accessible drives
Installing a LocalView module
8.2
Installing a LocalView module
The LocalView module is an optional extra for the servers of the PRIMERGY
series. On the display panel of the LocalView module you can read status
messages directly on the server. These status messages provide information on
the system and notify you of hardware faults (e.g. fan failure, CPU over voltage,
etc.).
The LocalView module can be pulled out like a sliding drawer. You can also
angle the LocalView display panel downward.
The LocalView module can be installed in the 3,5/0,5 inch bay of the FD drive.
Figure 33: LocalView module
Ê Open the server as described in the
chapter "Preparation" on page
21.
Ê remove the cover (see
"Removing cover" on page
48)
Ê If a FDD-dummy module is installed it must be removed (see
"Removing a
FD drive dummy module" on page
49).
Options Guide
53
RX300 S3
Advertisement
Table of Contents
