Processor
11.2.8 Concluding steps
Perform the following procedures to complete the task:
Ê Close the side cover as described in section
page
58.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section
page
59.
Ê If available, update the system board BIOS to the latest version as described
in section
"Updating the system board BIOS" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
11.3
Replacing the processor heat sink
Field Replaceable Units (FRU)
Average task duration: 15 minutes
11.3.1 Required tools
Preliminary and concluding steps: tool-less
●
Removing and installing the processor heat sink:
●
– Phillips PH2 / (+) No. 2 screw driver
232
"Connecting the server to the mains" on
82.
Upgrade and Maintenance Manual
"Installing the side cover" on
73.
"Enabling
TX100 S3