Saeco D.A. 5P Instruction And Maintenance Manual page 60

English
fig. 31
Soluble powder container
- Extract the container form its seat by slightly lifting it to make its
extraction easier (fig. 32). The soluble powder container doesn't
require special maintenance. Nevertheless, it should be cleaned
at least on a monthly basis, making sure that it's perfectly dried
when filled. The container may be separated from the back
bushing by rotating the latter clockwise, allowing back pin
and spring extraction. The front silicon bushing can be unfitted
by removing the special fixing spring. Clean everything with a
dry cloth or compressed air, then refit performing all opera-
tions in reverse order, making sure that the sealing ring of the
back pin is perfectly intact.
fig. 32
Water tank
The water tank should be emptied and cleaned every time it is
filled.
Dispensing slot area
Unfit the dispensing slot by simply extracting it from its seat. Sepa-
rate it from the grill, the tray and the drip tray and wash everything
with lukewarm water (fig. 33).
Important
The manufacture disclaims all responsibilities for possible mal-
functioning caused by improper or scarce maintenance.
fig. 33
28
9.3 Mix fan replacement
Remove the old fan, insert the new one in the special tang, rest the
wrench on the fan flanging and then press in the axial direction
until the wrench is in contact with the motor bearing surface (fig.
34). For further specific instructions, refer to the special mainte-
nance manual.
fig. 34
10 - VENDING MACHINE
SCRAPPING
The disposal of the wastes coming from vending machine scrap-
ping should be performed while respecting the environment, avoid-
ing ground, water and air pollution.
In any case local existing laws ruling the matter shall be complied
with. Make the vending machine unserviceable by disconnecting
the plug from the outlet and cutting the electric cable. Deliver the
unserviceable vending machine to a suitable disposal centre.
The information in this manual is subject to changes without notice
decided by the manufacturer. The contents of this manual are con-
fidential and no part of it may be reproduced in any form or mean,
be it electronic or mechanic, for any use, without manufacturer's
permission. The manufacturer disclaims any liabilities for inaccura-
cies arising out of printing or transcription errors.
11 - VARIATIONS
11.1 Model D.A. 3P/5P
(without clock module)
The vending machine model 3/5P without the clock module is
used in the same way, has the same intended use and compo-
nents of the more complete model.
The only difference is in the management of the fifth main menu
item (see "11.2 Programming structure" (3/5P model without clock
module)"); actually, in this model the fifth item "FREE VEND... "
manages two choice options "NEVER" and "ALWAYS" (In the ver-
sion with clock module this item is integrated in "TIME MANAGE-
MENT").