Saeco D.A. 5P Instruction And Maintenance Manual page 57

MESSAGE
OUT OF SERVICE
NO WATER
OUT OF SERVICE
NO COFFEE BEANS
OUT OF SERVICE
EMPTY GROUNDS
OUT OF SERVICE
NO BREW. UNIT
OUT OF SERVICE
STOP BEVERAGE
OUT OF SERVICE
STOP SOLUB.
OUT OF SERVICE
STOP WATER
CAUSE
Water is not reaching the dispens-
ers.
This happens when the grinder mo-
tor stays in operation for more than
a certain time without closing the
dosing switch.
This happens when the coffee
grounds tray has reached maximum
capacity.
The group was not inserted correct-
ly in its seat, or the group presence
micro-switch doesn't work.
The vending machine has reached
the programmed number of drinks.
The vending machine has reached
the programmed number of soluble
product 1 (or soluble product 2 or
soluble product 3) vends.
The vending machine has dispensed
the programmed quantity of water.
This happens when the turbine doesn't turn, and the electronic cir-
cuits receive no impulses, for example when the water supply finish-
es while a product is dispensed, or during filling at start up (the
pump doesn't work, or the group id dirty, or the solenoid valve is
jammed). Turning the vending machine off and on the signals remain
active because malfunctioning is detected once again during filling
procedure at start up. The vending machine is blocked in all its
functions, including temperature management (heater off): it's neces-
sary to fill up the water tank or check the presence of water in the
waterworks, and then to perform the filling procedure with the reset
key until a steady water jet doesn't come out. The out-of-service is
reset after having pressed the internal button the moment the pump
starts in order to perform filling; the user shall take care of continuing
the filling procedure until a regular water jet is coming out. If signal-
ling persists after dispensing, call a Service Centre.
The vending machine keypad functions are blocked: it's necessary
to fill the coffee container and turn the machine off and on. It may
also be reset by pressing the internal button. If signalling persists
after coffee dispensing, call a Service Centre.
The vending machine keypad functions are blocked. If the vending
machine is turned off and on again the signalling persists. The cof-
fee grounds tray must be emptied (micro-switch off for at least 5
seconds). Eight coffees before reaching the maximum coffee grounds
number (0..... 99), the display shows a warning message.
If by turning the vending machine off and on the signalling persists,
call a Service Centre. If the group is missing at start up, the vending
machine does not perform filling and group reset.
The vending machine keypad functions are blocked. If the vending
machine is turned off and on again the signalling persists. To reset
vending machine functions it's necessary to enter programming and
use the RESET function in the STOP menu.
The vending machine keypad functions are blocked. If the vending
machine is turned off and on again the signalling persists. To reset
vending machine functions see above.
The vending machine keypad functions are blocked. To reset vend-
ing machine functions see above. If the vending machine is turned
off and on again the signalling persists. To perform reset without
accessing programming (only in the case of it being out of service,
for example for operators that don't know the password) follow this
procedure:
- While pressing the RESET key, press the A key within 3 sec-
onds (ref. 3, fig. 6), the LED starts to flash.
- Press the C button for a short time (ref. 3, fig. 6) to confirm the
reset. If the C key is not pressed do (ref. 3, fig. 6) within 10
seconds the LED stops flashing and reset id not performed.
CURE
English
25